carefully place each crystal of your choice on your design

[Hildtdun]

Print the design of your swarovski crystal ireland choice on plain white paper using a deskjet or laser printer. If possible, try to use paper that is slightly smaller in size than your transfer film. After printing the design, take the transfer film and remove the white-non adhesive backing paper from the transfer film. Use tape and attach the corners of the transparent sheet on your design paper, taking care to keep the sticky side of the film on top.

Now with the help of tweezers, carefully swarovski crystal bracelets ireland place each crystal of your choice on your design. Choose colors that suit your design and match the fabric or garment on which you are creating your motif. Remember to place the rhinestones face up on your design. (If you do not want to use your design immediately you can replace the white sheet and store it for later use).

After you have put all the crystals in place, transfer swarovski crystal necklace ireland the entire setup onto your fabric taking care to use a hard surface as the base plate for the fabric. Ensure that the transfer film and design are placed exactly as you want the design to be on your fabric; the sticky side of the transfer film should be on the fabric. This will keep the design and the crystals in place.

Cover your design and the transfer swarovski crystal beads ireland film with PTFE sheet. It helps in protecting the sole plate of your iron and also creates a uniform heating surface. Move the preheated iron on the PTFE sheet. Make sure that the iron is preheated to a temperature suitable for your fabric. You will need to move the iron on the design for about 9 to 10 seconds for crystals of size 3mm to 4mm; larger crystals would require more ironing time. Maintaining correct temperature and timing is very essential to transfer the motif on your garments.

Once you are done ironing, allow the PTFE swarovski jewelry outlet ireland sheet to cool down and then peel off the transfer film slowly, inch by inch. Ideally, you should allow both the garment and the transfer film to reach room temperature and wait for at least 24 hours prior to removing the transfer film. Your design and motif will be transferred to the fabric and your garment is ready to use. Start exploring your creativity and stand out from the rest.
_________________
adidas gazelle mujer baratas